HiLetgo 5pcs LM386 Mono Audio Amplifier Module 200 Times AMP Solo 5V-12V 10K Adjustable

I teach junior high science, and in one of my lessons, I connected an LED to the audio output of my laptop so students could observe that the current changes directions inside a speaker. (LEDs have positive and negative terminals, so they only light up when the current is connected in the correct direction. So regular LEDs flicker on and off as the current changes, and two-color LEDs change colors). But the directions provided in the curriculum didn't work. Upon further reflection, LEDs require more current than my computer's audio output provides, so I needed an amplifier. But the amplifier sent with the curriculum didn't work either.So I brushed off my electronics skills and began preparing to build an amplifier using my capacitors, resistors, etc. One of the components I was lacking was the LM386 audio amplifier (which is one component of this piece of hardware). But this device was less expensive than buying all the missing components and building my own amplifier. Plus, you get 5 of them. I connected this amplifier to my LED and the experiment worked. (I had to bend the input pins so that the alligator clips from my audio-to-alligator-cable clips and wires from the battery could all connect, but there are circuit diagrams for this device easily found online).The sound quality wasn't great, but it would probably be better if this device were used as intended, soldered into a larger electronic device, rather than connected to other components using a breadboard. Also, the low-quality speaker I attached in parallel with the LED might have been part of the problem.

This is a great little amplifier for anyplace you need to boost signal levels. One helpful hint: If the gain of 200 is too high (and it usually is for me) just remove C1 to drop the gain to 20.

They are pretty good but at higher volume distorted. Will not run a 16 ohm speaker.They would be useless for playing at a rock concert unless you ask the audience to be very quiet and supply hearing aids.That being said I did make a mini guitar amp and the distortion is quite good.

Worked great. Used them to make a small guitar amp out of an old speaker. Added an input jack and ran it off a 9v battery. Sounds great at desktop volumes. Can even get a little breakup/distortion when cranked.

Easy to connect and it works

Great amplification with a homemade am radio. Volume pot a little iffy. Still very happy

Absolutely terrible. I went against my gut to believe the previous reviews and I was dead wrong. These barely worked. I'm better off going to buy a $10 bluetooth speaker at dollar store to take it's board out.

The sound/signal coming from these are very dirty.