JLTC CD0.8 Universal Plate Clamp, 1760 lb Working Load Limit (5-(Pack))

I use it in conjunction with a 2 ton engine hoist, to lift sheet steel onto my CNC plasma table. The thickest thus far is 1/2" material, but it lifts it fine. It will swing a little, but is is -not- a horizontal/vertical unit. It's got maybe 60 degrees of swing...meaning it may bend the area it's clamping if you try to drop a panel from vertical, until it rests horizontally on the floor. The thinnest I've used it on has been 14 gauge, and it works well. No slipping thus far. Quite satisfied at this point.

We use this clamp to lift and position 500-600 pound galvanized steel I beams for pile driving and it works just as it should. It will mar the surface if you are dragging it around at different pull directions but it has never failed it's grip. We tried some magnetic lifters but they will fail if the load swings or bounces and they loose hold capacity if you lift at an angle to the mating surface so this worked much better and safer than a lifting magnet.

works good with my gantry crane. I picked up a 3/16 4x8 sheet of metal with no problem.

works great. just what I needed

Works great for me!

A neat too for heavy lifting

Exactly what we needed.

this product is unsafe. We used it for a short time and it broke while lifting. after looking at where it broke, There is a major defect in these as where the break occurred the piece showed evidence that it had a crack in it. I would not buy this again and would return it, but the time has run out for that by 8 days.